ROLLING PIN FLAGSTONE 1676

Rolling Pin Flagstone 1676

Textured rolling pins capable of imprinting a continuous repeated pattern on clay and putties. Made of clear PMMA plastic with amazing non-stick properties. Non-toxic. They come in several textures that you can buy according to your specific needs.

Length: 14'50 cm (5'5 inch)

Diameter: 2'5cm (1 inch)

INSTRUCTIONS FOR USE:

• 1st - Knead the putty/clay well until ready according to the manufacturer’s recommendations.
• 2nd - Spread the putty/clay on a surface to be textured. For optimum results, ensure you have a smooth and even surface before imprinting with the rollers. We recommend using a plain roller for this.
• 3rd - Depending on the type of putty/clay, it is advisable to moisten the roller to prevent sticking.
• 4th - Move the rolling pin slowly, applying equal pressure at all points for an even texture.
• 5th - Trim off excess putty/clay with a sharp knife. It is recommended to do this after it has dried to avoid deforming the putty/clay.

MATERIALS:

There are numerous different types of putty and clay on the market, and all of them can be textured with the correct technique.

Usually, polymer clay (Fimo or Sculpey type) is quite easy to work with these rolling pins, as they allow for easy correction of errors before baking. If the intention is to create a textured base, we recommend using an MDF base, as you can texture the polymer clay directly on an MDF base and then place everything in the oven, including the base. The cooking time for these clays is about 15 minutes at 150ºC. MDF wood may leave a slight smell, similar to toasted bread, but don't worry, it will not burn!

In the case of epoxy putties, there are several techniques that achieve similar results. The good thing is, you don't need to bake them, so they can be applied directly to plastic bases.

For Green Stuff putty, which is particularly sticky, it is required to slightly moisten the putty or the roller with some water before texturing. You can also reduce stickiness by applying talcum powder or using Sculptor Vaseline.

Other epoxy putties like Milliput putty, for example, are also suitable, but we recommend not wetting them too much as this will hinder your work. Furthermore, if the mixture is too sticky, it is better to continue kneading until the stickiness is gone.

For these types of epoxy putties, it is very important to clean the rollers thoroughly after use.

MAINTENANCE INSTRUCTIONS:

After working with the rollers, use a scratch brush (LINK) and plenty of water to remove any residue on the rollers, if necessary.

SAFETY:

To ensure safety, children must be closely supervised by a responsible adult.