ROLLING PIN FACTORY GROUND 1224

Rolling Pin Factory Ground 1224

Rolling Pin - Factory Floor

Textured rollers capable of printing a continuous repeating pattern on clay and putty. Made of clear PMMA plastic with amazing non-stick properties. Non-toxic. They come in a variety of textures that you can purchase according to your specific needs.

Length: 14.50 cm (5.5 inches)

Diameter: 2.5 cm (1 inch)

INSTRUCTIONS FOR USE:

• 1st - Mix the putty/clay well until ready according to the manufacturer's recommendations.
• 2nd - Spread the putty/clay on a surface to be textured. For optimal results, ensure you have a smooth and even surface before impressing with the rollers. *** We recommend using a regular roller for this purpose.
• 3rd - Depending on the type of putty/clay, it is advisable to wet the roller to prevent sticking.
• 4th - Move the rolling pin slowly, applying equal pressure at all points for an even texture.
• 5th - Cut away excess putty/clay with a sharp knife. It is recommended to do this after it has dried to prevent deformations in the putty/clay.

MATERIALS:

There are numerous different types of putty and clay on the market, and all of them can be textured with the correct technique.

Usually, polymer clay (Fimo or Sculpey type) is quite easy to work with these rolling pins, as they allow for easy correction of mistakes before baking. If the intention is to create a textured base, we recommend using an MDF base, as you can texture the polymer clay directly onto an MDF base and then place everything, including the base, into the oven. The cooking time for these clays is approximately 15 minutes at 150ºC. MDF wood may leave a slight odor, similar to toasted bread, but don't worry, it will not burn!

In the case of epoxy putties, there are various techniques that yield similar results. The good thing is, you don't need to bake them, so they can be applied directly to plastic surfaces.

For Green Stuff putty, which is particularly sticky, it is required to lightly moisten the putty or the roller with some water before texturing. You can also reduce stickiness by applying talcum powder or using Sculptor Vaseline.

Other epoxy putties such as, for example, Milliput putty are also suitable, but we recommend not wetting them too much as this will hinder your work. Moreover, if the mixture is too sticky, it is better to continue kneading until the stickiness is gone.

*** For these types of epoxy putties, it is very important to clean the rollers thoroughly after use.

MAINTENANCE INSTRUCTIONS:

After working with the rollers, use a scratch brush (LINK) and plenty of water to remove any residue on the rollers, if necessary.

SAFETY:

To ensure safety, children should be closely supervised by a responsible adult.