ROLLING PIN AZTEC 1397

Rolling Pin Aztec 1397

Rolling Pin - Aztec

Textured rollers capable of impressing a continuous repeated pattern on clay and putties. Made from clear PMMA plastic with amazing non-stick properties. Non-toxic. They come in different textures that you can buy based on your specific needs.

Length: 14'50 cm (5'5 inch)

Diameter: 2'5cm (1 inch)

INSTRUCTIONS FOR USE:

• 1st - Mix the putty/clay well until ready according to the manufacturer's recommendations.
• 2nd - Spread the putty/clay on a surface to be textured. For optimal results, ensure you have a smooth and even surface before impressing with the rollers. We recommend using a regular roller for this purpose.
• 3rd - Depending on the type of putty/clay, it is advisable to wet the roller to prevent sticking.
• 4th - Move the rolling pin slowly, applying equal pressure at all points for an even texture.
• 5th - Cut off any excess putty/clay with a sharp knife. It is recommended to do this after it has dried to prevent deformations in the putty/clay.

MATERIALS:

There are numerous different types of putty and clay on the market and all of them can be textured with the correct technique.

Usually, polymer clay (Fimo or Sculpey type) is quite easy to work with these rolling pins, as they allow for easy correction of mistakes before baking. If the intention is to create a textured base, we recommend using an MDF base, as you can texture the polymer clay directly onto an MDF base and then place everything, including the base, in the oven. The cooking time for these clays is approximately 15 minutes at 150ºC. MDF wood may leave a slight smell, similar to that of toasted bread, but don't worry, it won't burn!

In the case of epoxy putties, there are different techniques that yield similar results. The good thing is, you don't need to bake them, so they can be applied directly to plastic surfaces.

For Green Stuff putty, which is particularly sticky, it is required to slightly moisten the putty or the roller with some water before texturing. You can also reduce stickiness by applying talcum powder or using Sculptor Vaseline.

Other epoxy putties such as, for example, Milliput putty are also suitable, but we recommend not to over-wet them as this will hinder your work. Furthermore, if the mixture is too sticky, it is better to continue kneading until the stickiness is gone.

For this type of epoxy putties, it is very important to clean the rollers thoroughly after use.

MAINTENANCE INSTRUCTIONS:

After working with the rollers, use a scratch brush (LINK) and plenty of water to remove any residue on the rollers, if necessary.

SAFETY:

To ensure safety, children should be closely supervised by a responsible adult.