ROLLING PIN ANCESTRAL RECALL 1504

Rolling Pin Ancestral Recall 1504

Textured rolling pins capable of impressing a continuous repeated pattern on clay and putty. Made of clear PMMA plastic with amazing non-stick properties. Non-toxic. They come in different textures that you can purchase according to your specific needs.

Length: 14'50 cm (5'5 inch)

Diameter: 2'5cm (1 inch)

INSTRUCTIONS FOR USE:

• 1st - Mix the putty/clay well until ready according to the manufacturer's recommendations.
• 2nd - Spread the putty/clay on a surface to be textured. For optimal results, ensure you have a smooth and even surface before impressing with the rollers. We recommend using a regular roller for this.
• 3rd - Depending on the type of putty/clay, it is advisable to wet the roller to prevent sticking.
• 4th - Move the rolling pin slowly, applying equal pressure at all points for a uniform texture.
• 5th - Cut away excess putty/clay with a sharp blade. It is recommended to do this after it has dried to prevent distortion of the putty/clay.

MATERIALS:

There are numerous different types of putty and clay on the market, and all can be textured with the proper technique.

Usually, polymer clay (Fimo or Sculpey type) is quite easy to work with these rolling pins, as they allow for easy correction of errors before baking. If the intention is to create a textured base, we recommend using an MDF base, as you can texture the polymer clay directly onto an MDF base and then place everything, including the base, into the oven. The cooking time for these clays is approximately 15 minutes at 150ºC. MDF wood may give off a slight odor, similar to toasted bread, but don't worry, it won't burn!

In the case of epoxy putties, there are different techniques that yield similar results. The good thing is, you don't need to bake them, so they can be applied directly to plastic surfaces.

For Green Stuff putty, which is particularly sticky, it is required to slightly moisten the putty or the roller with some water before texturing. You can also reduce stickiness by applying talcum powder or using Sculptor Vaseline.

Other epoxy putties like Milliput putty, for example, are also suitable, but we recommend not wetting them too much as this will hinder your work. Moreover, if the mixture is too sticky, it is better to continue kneading until the stickiness is gone.

For these types of epoxy putties, it is very important to clean the rollers thoroughly after use.

MAINTENANCE INSTRUCTIONS:

After working with the rollers, use a scratch brush and plenty of water to remove any residue on the rollers, if necessary.

SAFETY:

To ensure safety, children must be closely supervised by a responsible adult.